Fein ABLK18-1.3TE Manual De Instrucciones página 15

OBJ_BUCH-0000000259-001.book Page 15 Thursday, May 12, 2016 3:40 PM
Character Unit of measure-
ment, international
U
V
-1
n /min, min
0
r/min
n
m/min
S
M...
mm
Ø mm
mm
Fe 400
mm
Fe 600
mm
Fe 800
mm
Al 250
mm
mm
kg
L dB
pA
L
dB
wA
L
dB
pCpeak
K...
2
m/s
2
m/s
h
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
min, m/s
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have thor-
oughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 054 06 1). The documents mentioned should be
kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial safety
regulations.
Intended use of the power tool:
Hand-guided nibbler for cutting sheet metal, cut-outs and
tight curves in weather-protected environments without
water supply using the application tools and accessories
recommended by FEIN.
Unit of measure-
ment, national
V
, rpm, rpm
m/min
mm
mm
mm
mm
mm
mm
mm
mm
kg
dB
dB
dB
2
m/s
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
min, m/s
Explanation
Rated voltage
Stroke rate at no-load
Cutting speed
Size of metric thread
Diameter of a round part
Max. work-piece thickness for steel with up
2
to 400 N/mm
Max. work-piece thickness for steel with up
2
to 600 N/mm
Max. work-piece thickness for steel with up
2
to 800 N/mm
Max. work-piece thickness for aluminium with
2
up 250 N/mm
Diameter of pilot-drill for inside cut-outs
Min. inside curve radius
Weight according to EPTA-Procedure 01
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
Vibrational emission value according to EN 60745
(vector sum of three directions)
Vibrational emission value (nibbler)
Basic and derived units of measurement from the
international system of units SI.
Special safety instructions.
Wear personal protective equipment. Depending on appli-
cation, use face shield, safety goggles or safety glasses.
Where appropriate, wear dust mask, hearing protectors,
gloves and workshop apron capable of stopping small
abrasive or workpiece fragments. The eye protection
must be capable of stopping flying debris generated by
various operations. The dust mask or respirator must be
capable of filtrating particles generated by your opera-
tion. Prolonged exposure to high intensity noise may
cause hearing loss.
Secure the work piece firmly. A work piece that is
gripped tightly in a clamping device or vice, is more
secure than if held by hand.
Do not rivet or screw any name-plates or signs onto the
power tool. If the insulation is damaged, protection
against an electric shock will be ineffective. Adhesive
labels are recommended.
Do not use accessories which are not specifically
designed and recommended by the power tool manufac-
turer. Safe operation is not ensured merely because an
accessory fits your power tool.
en
15