Tabla de contenido
Publicidad
ENGLISH
•
Dampen your skin with water and apply face wash onto your skin. •Alternatively, apply
your face wash directly onto the brush.
•
TIP: If you are using the pre-shave attachment, apply a generous amount of face wash
directly to the brush head.
•
NOTE: We recommend cleansing with the Deep Clean brush in 3 sections: T-Zone (1),
Right side (2) and Left side (3).
•
Switch on using the On/Off button.
•
Place the facial brush directly onto your skin.
•
Gently glide the brush over the skin and beard in circular motions avoiding the delicate
eye area.
•
NOTE: Try to avoid applying too much pressure with the brush when directly on the
skin.
•
When not in use, store the brush attachments with the protective caps on.
•
Ensure the bristles are dry before attaching the protective cap.
CHANGING SHAVE / GROOMING HEADS
•
The shaver should be switched off when changing heads.
•
Grasp the shave head at the red collar and pull up to unsnap the head from the handle.
•
Attach the interchangeable heads to the handle by aligning the hexagon shapes of the
head to the handle, then pressing together to snap in place.
•
To remove the interchangeable heads gently pull the head upwards until it comes off
the main body of the product.
•
NOTE: The Deep Clean and Pre-shave head must be clicked into place on top of the
brush base. The brush base can then be connected onto the product by aligning the
hexagon shapes of the brush base to the handle as noted above.
GROOMING
•
Use the grooming styler head without the adjustable comb for trimming hair close to
the skin. This will trim hair to 1mm, holding the blades perpendicular to the skin will
trim hair to 0.4mm.
•
Attach the comb onto the groomer head by hooking the front of the comb over the
trimmer blades, then snapping the comb down onto the groomer.
•
Adjust the comb setting by rotating the thumb wheel at the top of the comb clockwise
to increase the cut length and anticlockwise to reduce the cut length. Read the setting
printed on the comb to select your desired length.
6
Comb Position
1
2
3
4
5
Cutting length
2mm
3mm
4mm
5mm
6mm
Publicidad
Tabla de contenido
