Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000295-001.book Page 18 Thursday, December 7, 2017 4:34 PM
en
18
Do not use the magnetic core drill unit when the cooling-
lubricant system is defective. Each time before operating,
check for tightness against leaks and for cracks in the
hoses. Prevent liquids from entering or penetrating elec-
trical components.
The core drills units do not have overload protection. In
case of improper use, the motor can become damaged.
Repair and customer service.
When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power tool.
The total insulation of the power tool can be impaired.
Blow out the interior of the power tool via the ventila-
tion slots frequently with dry and oil-free compressed air,
and connect a residual current device (RCD) on the line
side.
Renew stickers and warning indications on the power
tool when aged and worn.
Flush the cooling-lubricant system with water, clean and
drain it completely when not using the machine for peri-
ods longer than two weeks.
After several hours of operation, the play in the dove-tail
guide can increase. As a consequence, the drill motor can
glide alongside the dove-tail guide by itself. This will lead
to a malfunction; when the motor glides or runs down,
the cutter can become damaged. In this case, retighten all
fastening screws of the dove-tail guide adequately so that
the drilling motor can easily be moved manually, yet does
not glide by itself (see page 9).
For continuous operation, the cooling-lubricant system
must be flushed with water and cleaned approx. every
4 weeks.
If the supply cord of this power tool is damaged, it must
be replaced by a specially prepared cord available through
the FEIN customer service centre.
The current spare parts list for this power tool can be
found in the Internet at www.fein.com.
If required, you can change the following parts yourself:
Application tools, coolant tank, handle, chipping protec-
tor, clamping strap
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your power tool may include only
a part of the accessories described or shown in this
Instruction Manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Technical documents at: C. & E. Fein GmbH, C-DB_IA,
D-73529 Schwäbisch Gmünd
Environmental protection, disposal.
Packaging, worn out power tools and accessories should
be sorted for environmental-friendly recycling.
Publicidad
