Outdoor temperature area
CONNECT AC ADAPTER
Connect the supplied power adapter to the power jack, then
plug into a standard AC outlet.
NOTE
•
The batteries are only for back-up use. Always connect
the unit to the power grid source via AC/DC adapter.
•
Make sure the adapter is not obstructed and is easily
accessible to the unit.
•
The base station and adapter should not be exposed
to wet conditions. No objects filled with liquid, such as
vases, should be placed on the base station and adapter.
•
To completely disconnect from power, unplug adapter
from the mains.
REMOTE SENSOR
The main unit can collect data from up to 3 sensors.
To set up the sensor:
1. Open the battery compartment (see FIG 3).
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any location
on the exterior of the home at a height of not more than 5 ft
and which can shield it from direct sunlight or wet conditions
for an accurate reading.
BAR208S_SA_UM_EN_OP-20170412.indd 4
Sensor batteries low
4
1.5 m (5 ft)
NOTE Use alkaline batteries for longer usage and consumer
grade lithium batteries in temperatures below freezing.
SENSOR DATA TRANSMISSION
To search for a sensor:
Press and hold
+ MODE.
The sensor reception icon in the remote sensor area shows
the status:
ICON
DESCRIPTION
Main unit is searching for
sensor(s)
4/12/17 5:36 PM