Casals CPBLI20K2 Manual Del Usuario página 7

If the model of your appliance does not
have the accessories described above,
they can also be bought separately from
the Technical Assistance Service.
Charging the battery
Caution: A new battery is not fully charged
and must therefore be charged before the
appliance is used for the first time.
Caution: During the handling of batteries,
do not touch both poles at the same time,
as this will provoke the partial discharge
of the stocked energy therefore affecting
longevity.
- Charge the battery at an atmospheric tem-
perature of between 4 and 40ºC.
- When the battery is empty, the appliance
is switched off by means of a protective
circuit. The inserted tool no longer rotates.
- Plug the charger (11) into the mains. And
the green pilot light will turn on
- Remove the battery (9) from the appliance
by pressing the battery unlocking button (8)
and pulling the battery out of the appliance
- Insert the battery (9) into the charger (11).
(Fig B)
- The green pilot light will turn off and the
red pilot will turn on to indicate that the bat-
tery is under charging process.
- Once the charge is completed the red pi-
lot light will turn off and green pilot light will
turn on.
- When the battery is charged disconnect
the charger from the mains supply.
- Remove the battery (9) pressing the bat-
tery unlocking button (8) and pulling the
battery out of the appliance.
Check battery charge (Fig. A)
- Press the button (14) and the battery pilot
lights will indicate the level of charge
Instructions for use
Before use:
- Make sure that all the product's packaging has
been removed.
- Ensure that the voltage indicated on the rating
label matches the mains voltage before plug-
ging in the appliance.
- Before using this product for the first time, it
is important to make a full charge of batteries.
Inserting a bit:
- To open the drill's chuck (1), whilst completely
switched off, take firm hold of the back part of
the chuck and turn the front part of the chuck
counter clockwise.
- Insert the drill bit, screwdriver bit, or other tool/
accessory required for the task, into the chuck.
In order to obtain a secure fastening of the bit,
insert the bit as far as you can into the chuck.
Take firm hold of the back part of the chuck and
turn the front part of the chuck clockwise until it
is firmly closed.
- In order to remove accessories from the
chuck, follow the same steps as indicated pre-
viously but in reverse order
Screwing, drilling/unscrewing:
- To drill or screw, ALWAYS have the direction
set to clockwise (CW).
- To unscrew, set the direction to counter clock-
wise (CCW).
- The appliance should not be in use when
changing the screwing direction.
How to select the direction of the rotation
(Fig A)
- Do not change the direction of the rotation
whilst the tool motor is in operation.
- The appliance has a selector (6), which allows
the direction of rotation to be changed.
7