Wtwist-Lock; Twist-Lock Fastener - Sauder Office Port 408293 Manual De Usuario

Step 5
Diagram 1. Measure 2" from one end of the INTERLOCK TRACK (V). Position the INTERLOCK TRACK as shown.
å
ACTUATOR / TRACK ATTACHMENT:
å
Diagram 2. Tilt the fi rst edge of the INTERLOCK TRACK (V) into the CABINET ACTUATOR (AA).
Diagram 3. Rotate the INTERLOCK TRACK and apply force to engage the second edge into the CABINET ACTUATOR.
å
Diagram 4. Repeat the ACTUATOR / TRACK ATTACHMENT for the next CABINET ACTUATOR while holding the
å
previously completed CABINET ACTUATOR in its location hole
Diagram 5. Remove the INTERLOCK TRACK assembly from Diagram 4 and fl ip it over before inserting the INTERLOCK
å
TRACK (V) with CABINET ACTUATORS (AA) into the groove in the INTERLOCK EXTENSION (N).
Edge with
TWIST-LOCK®
FASTENERS
www.sauder.com/services
Be sure the
interlock track
snaps into each
cabinet actuator.
A
5.
V
N
The interlock system is a safety feature
that prevents more than one drawer
from opening at the same time. Do not
use excessive force to open the drawers.
V
AA
4.
2.
408293
1.
V
Tape Measure
V
3.
AA
Page 9