Black 1-9/16" Flat Head Screw - Sauder Office Port 408293 Manual De Usuario

Step 14
The tabs should insert freely into the
1
slots. Gently tilt the DRAWER SIDES side
to side until the tabs slip into the slots.
D87
Groove
Insert the DRAWER SIDES (D87 and D88) at an
å
angle into the slot at each end of the UPPER
DRAWER FRONT (G2).
3
Minimum
190 degrees
M63
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (M63) to the UPPER
å
DRAWER FRONT (G2). Tighten one HIDDEN CAM.
Page 18
D88
G2
Maximum
Arrow
210 degrees
G2
VIEW THE T-LOCK BOX VIDEO
With the palm of your hand, tap the
2
DRAWER BOTTOM down into the groove.
U n
fi n
s u
i s h
r f a
c e
D87
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D729) into the grooves in
å
the DRAWER SIDES (D87 and D88) and UPPER
DRAWER FRONT (G2).
4
D87
M63
Fasten the DRAWER BACK (D61) to the DRAWER
å
SIDES (D87 and D88) and DRAWER BRACE (M63). Use
five BLACK 1-9/16" FLAT HEAD SCREWS. (30S). Repeat
this step for the other DRAWER.
408293
e d
D729
D88
G2
Start each screw a few turns before
completely tightening any of them.
30S

BLACK 1-9/16" FLAT HEAD SCREW

(10 used in this step)
D61
D88
www.sauder.com/services