Troubleshooting; Environmental Protection - Worx WG707E Traducción De Las Instrucciones Originales

TROUBLE SHOOTING
Symptom
Machine fails to operate
Machine functions
intermittently
Machine leaves ragged
Finish or motor labours
Cutting blade not rotating
while machine switched on
Excessive vibration/noise

ENVIRONMENTAL PROTECTION

Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice.
Electric lawn mower
Possible cause
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Mower in long grass
Motor protector has
activated
Extension cable damaged
Machines internal wiring
damaged
Motor protector has
activated
Height of cut too low
Cutting blade blunt
Underside of machine badly
clogged
Blade fitted upside down
Cutting blade obstructed
Blade nut/bolt loose
Blade nut/bolt loose
Cutting blade damaged
Remedy
Turn power on
Use another socket
Inspect cable, replace if
damaged
Replace fuse
Increase height of cut and tilt
mower
Release the switch lever,
Clear any obstruction,
increase height of cut, then
restart it
Inspect cable, replace if
damaged
Contact Service Agent
Release the switch lever,
Clear any obstruction,
increase height of cut, then
restart it
Increase height of cut
(see " ADJUSTING ThE
CUTTING hEIGhT ")
Replace blade
(see "Blade Maintenance")
Clean machine (see
"Storage")
Refit blade correctly (see
"Blade Maintenance")
Clear obstruction
Tighten blade nut/bolt
Tighten blade nut/bolt
Replace blade
13 13
EN