Environmental Protection; Troubleshooting - Worx WG789E Manual Original

STORAGE (See S)
Stop the mower and always remove the
safety key. Clean the exterior of the machine
thoroughly using a soft brush and cloth. Do
not use water, solvents or polishes. Remove
all grass and debris, especially from the
ventilation slots.
Turn the machine on its side and clean the
blade area. If grass cuttings are compacted
in the blade area, remove with a wooden or
plastic implement.
Store the machine in a dry place. Do not place
other objects on top of the machine.
To aid storage, press the handle height
adjustment knob, and rotate or fold the upper
handle.
TROUBLE SHOOTING
Problem
1. Mower doesn't run when
switch lever is activated.
2. Motor stops while mowing.
3. Mower runs but cutting
performance is unsatisfactory,
or does not cut entire lawn.
4. Mower is too hard to push.
Cordless self-propelled lawn mower
All manuals and user guides at all-guides.com
ENVIRONMENTAL
PROTECTION
this product shall not be discarded with
household waste but that it shall be returned
to a collection system which conforms to the
European Directive 2002/96/CE. It will then
be recycled or dismantled in order to reduce
the impact on the environment. Electric and
electronic equipment can be hazardous for the
environment and for human health since they
contain hazardous substances.
A. Check to make sure safety key has been installed and
is fully seated and that button on switch housing is being
completely pushed.
B. Release switch lever to turn mower off. Remove safety key,
turn mower over and check that blade is free to turn. Clear
any obstruction. If not free, return to an authorized servicer.
Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait
for green light to come on.
A. Release switch lever to turn mower off. Remove safety key,
turn mower over and check that blade is free to turn. Clear
any obstruction. If not free, return to an authorized servicer.
Blade should turn freely.
B. Raise cutting height of wheels to highest position and start
mower.
C. Has battery been fully charged? Plug in charger and wait
for green light to come on.
D. Avoid overloading the mower. Slow down the cutting pace
by pushing mower slower or raise the cut height. Or both.
A. Has battery been fully charged? Plug in charger and wait
for green light to come on. "
B. Release switch lever to turn mower off. Remove safety key.
Turn mower over and check: Blade for sharpness - Keep blade
sharp. Deck and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass
condition. Raise cutting height.
A. Raise cutting height to reduce deck drag on grass. Check
each wheel for free rotation.
This product has been marked with a
symbol relating to removing electric
and electronic waste. This means that
Solution
17
EN