Operation; Switching On / Off - Hilti SID 2-A Manual De Instrucciones

2. CAUTION A falling battery may present a risk of injury to yourself
and others.
Check that the battery is seated securely.
5.3 Removing the battery
1. Press the release button.
2. Pull the battery out of the cordless impact screwdriver towards the front.
5.4 Belt hook (accessory)
CAUTION
Check that the belt hook is fitted securely before beginning work.
The belt hook can be used to attach the cordless impact screwdriver to a
belt worn close to the body. The belt hook can also be fitted to the other
side of the power tool for use by left-handed persons.
1. Remove the battery from the cordless impact screwdriver.
2. Insert the belt hook in the fitting provided.
3. Secure the belt hook with the two screws.

6 Operation

6.1 Setting forward or reverse rotation
The forward / reverse switch is used to select the direction of rotation of the
drive spindle. An interlock prevents switching while the motor is running.
When the forward / reverse switch is in the middle position the control switch
is locked.
Push the forward / reverse switch to the left.
The tool is set to forward rotation.
Push the forward / reverse switch to the right.
The tool is set to reverse rotation.

6.2 Switching on / off

Speed of rotation can be increased smoothly up to maximum speed by
pressing the control switch slowly.
NOTE
If the cordless impact screwdriver switches itself off automatically due to
overloading or overheating, release the control switch and wait until the
tool has cooled down. The tool can subsequently be switched on again by
pressing the control switch.
Printed: 12.11.2014 | Doc-Nr: PUB / 5206157 / 000 / 00
3
4
5
en
11