JVC KD-S821R Manual De Servicio página 9

Ocultar thumbs Ver también para KD-S821R:
Tabla de contenido

Publicidad

Removing the CD mechanism assembly
Prior to performing the following procedure, remove
the CD mechanism control board and the front
bracket (loading motor).
1.
Remove the three screws D
bracket.
2.
Raise the both sides fix arms and move the fix plates
in the direction of the arrow to place the four shafts g
as shown in Fig.8 and 9.
3.
Remove the CD mechanism assembly and the two
springs h attaching the flame.
4.
Remove the two screws E
damper brackets from the dampers. Detach the CD
mechanism assembly from the left side to the right
side.
ATTENTION:
The CD mechanism assembly can be
removed if only the rear damper
bracket on the left side is removed.
CD mechanism
(See Fig.1, 6 to 9)
and the damper
and both sides rear
assembly
D
h
Front bracket
assembly
CD mechanism
D
Flame
h
D
Rear damper bracket
Fix plate (L)
g
Rear damper bracket
Fix arm (R)
E
Damper
KD-S821R
Damper bracket
D
a
h
c
D
d
CD mechanism
e
A
control board
b
Fig.5
Damper bracket
D
Fig.6
D
Fig.7
Fix arm (L)
E
g
Damper
Fig.8
Fix plate(R)
g
g
Fig.9
h
1-9

Publicidad

Tabla de contenido
loading

Tabla de contenido