Maintenance Schedule - HUSTLER X-ONE Manual Del Usuario

CZ
Verify safety start interlock system
DA Visually inspect unit for loose hardware and/or damaged parts
Visually inspect tires
Check oil level, engine (1) (4)
Clean air intake screen (8)
Check fuel level
Blades - sharpen & securely fastened
DE
Discharge chute - securely in place & in lowest position
Rear discharge deck flaps and/or power unit deflector securely in place
Clean engine and pump compartment (13)
Check air cleaner service indicator (8)
Replace engine air cleaner element (5) (10)
EN
Caster fork tapered bearings (11)
Change engine oil and filter (1) (4)
Clean cylinder and head fins (10)
Check battery connections (13)
Check tire pressure with a gauge
ES
Check hydraulic oil level (13)
Clean engine exterior (10)
Tighten lug nuts on wheels (2)
Grease deck pusher arms (8)
Grease pump idler (8)
FR
Grease deck height pivots (8)
Grease front wheel bearings (8) (12)
Clean & regap spark plugs (10)
Check pump and deck belt tension and condition (6) (13)
Check fuel system (7) (13)
IT
Check fuel valve (7)
Check fuel tank grommets (7)
Change fuel filter (7)
Change hydraulic filter & oil (3) (13)
Grease deck spindle housings
NL
Replace spark plugs (10)
Check ROPS mounting hardware (9)
Replace fuel evaporation system filter (8) (13)
NOTES:
Initial engine oil change is after 5 hours of operation. Thereafter, change oil after every 40 hours operation. Change more often under dusty or
1.
dirty conditions and during hot weather periods. Hustler
PT
Torque initially and after first 2 hours of operation.
2.
Perform initial hydraulic oil and filter change after 750 hours of operation. Thereafter, change oil and filter every 500 hours (every 750 hours for
3.
Hustler ® 100% Synthetic Hydrostatic Transmission Oil or Parker HT-1000 oil).
Change engine oil filter per the engine manufacturer's recommendations. Refer to Engine Owner's Manual for recommendations and other
4.
maintenance items.
Service more often under dusty or dirty conditions. Use caution when servicing to prevent dust contamination in the engine. Do not clean filter
5.
element. Replace with a new one.
SV
Pump drive belt only - Inspect belt every 100 hours and replace if worn or cracking is noticed. Check spring tension adjustment. Otherwise,
6.
replace belt every 400 hours or 2 years whichever comes first. Check and adjust spring tension after 50 hours of use as outlined in the Hydraulic
Pump Belt Adjustment section of the General Service Manual (123940).
REV C

Maintenance Schedule

Refer to Figure 4-19, Figure 4-20, Figure 4-21, & Figure 4-22
SERVICE AT
INTERVALS INDICATED
® Motor Oil is recommended.
WEEKLY
OR 50
HOURS
Prior to each use or every 4 hours
Prior to each use or every 4 hours
Regular maintenance not required
X
X
X
X
X
X
X
4-10
MONTHLY * ANNUALLY
OR 100 OR 500
HOURS HOURS
Prior to each use
Prior to each use
Prior to each use
Prior to each use
Prior to each use
Prior to each use
Prior to each use
Daily
Daily
As needed
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
606839CE