-
This machine is intended for professional bakers ;
-
This machine is solely intended for cutting temperate baked bread ;
-
It may only be used by one person at a time. (unless otherwise stated) ;
-
It has to be kept and used inside in a location, away from humidity and heat ;
-
The machine has to be adequately lit for carrying out the work satisfactorily ;
-
This machine has a noise level below < 64,8 dB(A) ±5 dB(A) as per standard EN ISO
3746.
-
For machines without special field sources: Non-ionizing radiation is not intentionally
produced, but only for technical reasons of the electrical equipment (such as electric
motors, power lines, or magnetic coils) only. In addition, the machine has no strong
permanent magnets. While maintaining a safe distance (distance to source field implant)
of 30 cm can be ruled out the influence of active implants (ex. pacemakers, defibrilla-
tors) with high probability.
-
Before connecting your machine to the electricity network, check that the machine op-
eration voltage (see rating plate on the machine) and voltage of the electricity network
are appropriate ;
-
Connection of the machine has to be made using an earthed plug ;
-
Your electrical installation supplying the machine has to be protected as below :
-
North America : Main protection 15A ;
-
Rest of the world : Main protection 16 A.
Note : All other problems resulting from another type of connection will not be taken into
account.
-
If necessary fix the feet or casters (if with stand) delivered with the machine ;
-
Check the direction of the blade rotation; if necessary reverse 2 phase wires ;
-
Please refer to the "Instructions for use" section for using the machine.
CAUTION
CONNECTION
START-UP
6