Tlgb 20 Set Up; Install/Replace Grease Cartridge; Prime The Grease Gun; Priming Instructions - SKF A Serie Instrucciones De Uso

TLGB 20 Set up

Install/replace grease
cartridge
1 Loosen the grease tube assembly (1) from
the pump assembly (9) a few turns, but do
not remove.
2 Pull back on the follower handle (12) and
latch the follower rod groove into the slot
on the tube cap († fig. 2).
3 Unscrew the grease tube assembly (1) from
the grease gun.
4 Remove the plastic cap from the grease car-
tridge and insert cartridge into the con-
tainer tube.
5 Remove pull tab from grease cartridge and
screw the grease tube assembly (1) into
the pump assembly (9).
6 Thread grease tube assembly (1) back onto
the power head.
9
1
7 Using follower handle (12), release follow-
er rod from slot.
8 Purge air from grease tube by unscrewing
vent valve (8) 2-3 turns until grease flows
from the valve († fig. 1, pg.
9 Retighten vent valve (8). Refer to
Expelling air pockets,
!
Notice
Air pockets in lubricant will cause
gun to lose prime.
1
10

Prime the grease gun

Prime the cordless grease gun after each re-
fill or grease cartridge change.
9).

Priming instructions

pg. 12.
Prime the cordless grease gun after each re-
fill or grease cartridge change.
1
Open vent valve (8)
2
Squeeze gun trigger until grease flows from
vent valve.
3
Close vent valve.
4 Press button "1" (4) 3 seconds to clear dis-
play (5) of previous reading
(† fig. 3, pg.
12
(† fig. 1, pg. 9).
11).
Fig. 2