Adjusting The Volume; Turning Off The Power - Boss ME-70 El Manual Del Propietario

INPUTPHONESPOWER ONREC OUT
AC Adaptor PSA series
(sold separately)
Be sure to use a PSA
series adaptor. The use
of any other adaptor
may cause malfunction.
To prevent the inadvertent disruption of power to your
unit (should the plug be pulled out accidentally), and to
avoid applying undue stress to the AC adaptor jack, anchor
the power cord using the cord hook, as shown in the
illustration.
Connect a commercially available
anti-theft security cable here.
http://www.kensington.com/
PCS-31L cable
(Sold separately)
White (L)
Red (R)
Inserting a plug into the REC OUT/PHONES jack
automatically activates the built-in guitar-amp
simulator, enabling you to enjoy impressive guitar
sound even with headphones.
The same effect is applied to Gt. AMP OUTPUT at
this time, too.
When you're performing using a guitar amp
connected to Gt. AMP OUTPUT, disconnect the
plug from the REC OUT/PHONES jack.
Digital Recorder, etc.

Adjusting the Volume

1.
Adjust the OUTPUT LEVEL knob.
Raising the OUTPUT LEVEL knob too much may result in sound distortion.
When the OUTPUT LEVEL knob is centered and all effects are off, input and
output are at the same level.

Turning Off the Power

1.
Turn down the volume all the way on all equipment
(this unit, the amplifier, and everything else).
2.
Switch off the amp and other connected devices.
3.
Unplug the guitar or other instrument connected to
the INPUT jack on the ME-70.
The power to the ME-70 is switched off.
guitar-amp simulatorGt.AMP
OUTPUT
Should you encounter unexpected results,
such as no sound being produced, check the
following.
• Are connections to other devices correctly made?
Check the connections once more.
• Is the volume turned down?
Check the volume levels on any connected amp or mixer.
• Can you hear sound through the headphones when
headphones are connected?
If you can hear sounds, it may be that there is a short in the cable
used to connect the amp or other device, or perhaps a mistake in
an external device's settings. Check the connecting cables and
external devices once more.
• Has the level been lowered with the expression pedal?
Sounds are not output when the toe of the expression
pedal is in the raised position while the pedal is set to
function as a volume pedal (p. E-9).
Creating Sounds
Expression
Pedal
E-3