Saving/Calling Up And Using Tones (Memory Mode); Changing Between The Manual And Memory Modes; Saving Tones (Patch Write) - Boss ME-70 El Manual Del Propietario

Saving/Calling Up and Using Tones
(Memory Mode)
The ME-70 has two primary operating modes: Manual mode and Memory mode. In Manual mode, the tones are produced by the actual positions
of the front-panel knobs for the various effects. In contrast, Memory mode allows you to save tone settings and recall them for later use.
Patches and Banks
In Memory mode, a combination (or set) of effects together with a
group of parameter settings is called a "patch."
A group of four patches is called a "bank," and the respective
patches in a bank correspond to the number pedals.
The banks are organized into nine "user banks" that you can freely
read from or write to, and nine read-only "preset banks."
In total, the ME-70 has 72 patches.

Changing Between the Manual and Memory Modes

1.
Press number pedals 3 and 4 at the same time.
2.
Each press switches the ME-70 between Manual
mode and Memory mode.

Saving Tones (Patch Write)

This saves the control settings in a patch.
You can perform patch-write operations either in Manual mode or in Memory
mode.
Performing a patch-write operation switches the unit into Memory mode.
Until you perform a patch-write operation, switching off the power or changing
patches will cause any tones you've created to be lost.
Carrying out a write operation causes any tone already saved at the destination
patch to be lost.
fig.0270
Pedal
Indicators
E-10
1
1, 3 2 2
User Bank 9
User Bank 3
User Bank 2
Patch Patch Patch Patch
User Bank 1
Patch Patch Patch Patch
Patch Patch Patch Patch
Patch Patch Patch Patch
You can read from
and write to these
without restriction.
When the unit is in Manual mode, the dot at the bottom right
of the display lights up. When the unit is in Memory mode, the
currently selected bank number is displayed.
Manual Mode
1.
Press [WRITE].
The pedal indicators flash.
2.
Choose the user bank and patch number where
you'd like to save the patch.
Choose the user bank number by pressing BANK [
Choose the patch number by pressing a number pedal (1 through 4).
To stop the Write procedure, press [EDIT/EXIT].
3.
Press [WRITE] again.
The tone is saved.
To copy a patch, call up the patch you want to copy (p. E-11), then simply carry
out a write operation. You can copy the patch by choosing a different patch
number and saving it there.
Preset Bank 9
Preset Bank 3
Preset Bank 2
Patch Patch Patch Patch
Preset Bank 1
Patch Patch Patch Patch
Patch Patch Patch Patch
Patch Patch Patch Patch
These are read-only.
(Writing to them is not possible.)
Number Pedals
Memory Mode Memory Mode
(User Bank 1) (Preset Bank 2)
] and [ ].