Step9: Connecting Drain Hose; Drain Requirements - Signature UPDF9904ST Características Detalladas Del Producto

Step9: Connecting Drain
Hose
40"
(101.6 cm)
max.
12"
(30.5 cm)
min.
If the end of the drain hose does not fit the drain
line, use a heat and detergent resistant adapter
(not supplied). These may be obtained from a local
plumbing shop.
The two typical connections are shown. To prevent
siphoning, one of the following connections should be
used.
/ "
5
8
(16 mm)
For air gap connections,
cut off drain hose at
dotted line

Drain Requirements

1
Follow local codes and ordinances.
2
Do not exceed 12 ft. (3.65 m) distance to drain.
3
Do not connect drain lines from other devices to
the dishwasher drain hose.
4
If an extension drain hose is required, use
or / " inside diameter, 2-3 ft. length hose and a
7
8
coupler for connecting the two hose ends.
Hose clamp
For drain hose installation, use the screw style clamp
provided with this dishwasher in the silverware
basket.
1"
/ "
3
4
(25 mm)
(19 mm)
For disposal or waste
Tee connections
/ "
5
8
Coupler Hose clamp
Connecting to Disposal with No Air
Gap
1
Remove the knockout plug with a hammer and
screwdriver.
2
Attach the drain hose to disposal with the hose
clamp provided. Move into position and tighten
the hose clamp.
Connecting Waste Tee with No Air
Gap
1
Remove the knockout plug with a hammer and
screwdriver.
2
Attach the drain hose to waste tee with the hose
clamp provided. Move into position and tighten
the hose clamp.
17
INSTALLATION