Signature UPDF9904ST Características Detalladas Del Producto página 41

Problem
Spots and filming on
dishes.
Noise
Possible Cause
Low water temperature.
Wrong amount of detergent used.
Overloading.
Improper loading.
Insufficient water pressure.
Insufficient detergent.
Rinse aid dispenser is empty.
Extremely hard water
Hard water buildup in the tub
Some level of noise is normal
during operation.
The dishwasher is not level.
Nozzle arm knocking against
dishes.
TROUBLESHOOTING
Solutions
• Water supply should be at least 120 °F
for best wash performance.
• Use the recommended amount of
detergent.
• Do not overload the dishwasher.
• See the Operation section.
• Water pressure should be between 20
and 80 psi.
• Add the recommended amount of
detergent. See the Operation section.
• Refill rinse aid dispenser.
• The best way to eliminate spots on
your dishes is to install a whole house
water softener in your home. If a water
softener is already installed or you do
not plan on installing one, try adding the
Extra Rinse option as part of the wash
cycle to help minimize this condition. To
add an extra rinse to the cycle, select
the wash cycle and then press Rinse.
NOTE
Selecting Extra Rinse will increase
cycle times and water usage.
• Remove all dishes, silverware and
silverware holder from dishwasher.
Only racks should remain in tub. For
best results, use citric acid powder (can
be found in canning sections of most
grocery stores or online). Measure 3
tablespoons (45 g) of citric acid powder.
Fill main wash compartment with
measured powder. If you cannot find
citric acid powder, pour approximately
1 ¾ -2 cups (400-500mL) of white
vinegar into shallow bowl and place in
lower rack. Run Normal cycle with Extra
Rinse and Sanitary options. DO NOT
USE DETERGENT.
• Detergent cover opening.
• Drain pump at the beginning of drain
cycle.
• Adjust leveling feet.
• Reposition the dishes.
41