20 Operation; Using The Dishwasher; Before Using The Dishwasher; Quick Start - Signature UPDF9904ST Características Detalladas Del Producto

20 OPERATION

OPERATION

Using the Dishwasher

Before Using the Dishwasher

• Read the Important Safety Instructions.
• Connect to the hot water supply only. The water
supply temperature should be a minimum of 120°F
(40°C) for better washing performance and shorter
cycle time.
• Follow the instructions for loading the dishwasher
to ensure effective cleaning.
• Remove insoluble items such as bones, toothpicks,
and pieces of paper while loading the dishwasher.
When loading the dishwasher:
1
Place items with deep dish bottoms at an angle
to help water run off and speed the drying
process.
2
Remove solid, burned-on scraps from dishes
prior to loading in the dishwasher.
3
Only load items that are dishwasher-safe.
NOTE
Do not load utensils that are not heat-resistant or
have decorative metal trim.

Quick Start

1
Load the Dishes
Scrape the dishes free of excess food, bones,
and any other hard, non-soluble residue. Pull
each rack out and load the dishes as described
in this manual.
2
Measure the Detergent
Using the guidelines in this manual, fill the
detergent cup with the recommended amount
of detergent and close the lid. If a prewash is
desired, the recess on top of the lid should also
be filled with detergent.
3
Turn on the Dishwasher
To turn on the display panel, press the Power
button.
4
Check the Rinse Aid
The Rinse Aid indicator light will illuminate if
the level of rinse aid in the dishwasher is low.
Add rinse aid if the level is low to maintain the
effectiveness of the dry cycle.
5
Select the Cycle and Options
Select the cycle and options that best fit the
load by referring to the Cycle guide. The display
will show the estimated time for the cycle and
options selected.
6
Close the Door
The dishwasher will start automatically, after
a slight delay, when the door is closed and
latched. During the cycle, the display will indicate
the estimated time remaining for the cycle and
options selected. If the door is opened during the
cycle, the dishwasher will stop. When the door
is closed, the cycle will resume from the point
where it was stopped.
7
End of Cycle
When the cycle is complete, a chime will sound
and the display will show End. After a short time,
the display and controls will shut off for safety
and energy conservation.
CAUTION
Empty the lower rack first and then the upper
rack. This will avoid water dripping from the upper
rack onto dishes in the lower rack.
WARNING
In general, it is not advisable to open the door
while the dishwasher is in operation. If the door
is opened, a safety device stops the dishwasher.
Care should be taken when opening the door
immediately following the cycle, as steam may
escape.

Auto-Off

The dishwasher will automatically turn off if a cycle
is not selected or if the door is not closed within four
minutes of being powered on.