Signature UPDF9904ST Características Detalladas Del Producto página 22

22 OPERATION
Extra Rinse
The Extra Rinse symbol indicates that an extra rinse
has been added to the cycle. An extra rinse can help
reduce hard water spotting on dishes. To add an extra
rinse, press Rinse repeatedly until the Extra Rinse
symbol appears in the display.
Rinse Only
This cycle is a quick rinse for dishes that will not be
washed immediately. The cycle rinses dishes that
have excess soil to soften dried on residue. Rinsing
the dishes helps prevent odors in the dishwasher. No
detergent should be used. To select the Rinse Only
cycle, turn the dishwasher on, and press Rinse once
without pressing any other cycle buttons. The Rinse
Only cycle is not available with any other cycles.
NOTE
The Rinse Aid symbol indicates that the rinse
aid needs to be refilled.
11 High Temp
Raises the main wash temperature to improve
cleaning.
12 Half Load
UPPER
For small loads, use just the upper or lower rack to
save energy. Each press of the Half Load button
cycles between the upper rack only and the lower
rack only.
13 Delay Start
The Delay Start feature delays the start of a selected
cycle. Each time the Delay Start button is pressed,
the delay time increases by an hour. The delay
time can be set from 1 to 19 hours, in one-hour
increments.
14 Child Lock
The Child Lock feature helps prevent settings from
being changed during a cycle. Selecting this feature
locks all of the buttons, except for the Power button,
on the control panel. This feature does not lock the
door.
Activating the Child Lock:
1
Open the dishwasher door.
2
Press Power.
3
Select the cycle (and desired options).
4
Press and hold Rinse and High Temp for three
seconds. The Child Lock indicator illuminates
on the display once the Child Lock is activated.
5
Close the door to begin the cycle.
LOWER
15 Digital Display
The digital display on the control panel shows the
ESTIMATED cycle time. When the dishwasher is
powered up, the display is blank. When the cycle
and options are selected, the display shows the total
estimated time to complete those selections. During
operation, the display shows the remaining estimated
operating time.
NOTE
• The estimated time shown in the display does
not include delay times for heating water, etc.
• If Delay Start is selected, the display shows the
delay time in hours.
• Cycle time may vary depending on the soil level
of your load.
16 Energy Saving
The Energy Saving option saves energy by using less
water. This option should only be used with light to
medium soiled dishes.
Press and hold Half Load and Delay Start at the
same time about three seconds.
17 Connect
When the appliance is connected to the internet
through a home Wi-Fi network, this indicator appears.
Press and hold Delay Start for approximately three
seconds.
18 Power
• Press Power to turn on the control panel. If
no cycle is selected within four minutes, the
dishwasher powers off.
• After the cycle is complete, the power automatically
turns off for purposes of safety and economy.
• If there is a power surge, power outage, or
disruption of any kind, the PF indicator displays and
power is automatically turned off for safety. Restart
the cycle.