Clock Adjustment; Meter Display And Reset; How To Access The Programming Mode - Cimbali M2 Manual Del Usuario

English

1. Clock adjustment

Use the "+" (30) and "-" (31) keys to adjust the clock.
The time increases (or decreases) one minute each time
the key is pressed.
If one of the keys (30 or 31) is pressed and held down for more
than 10 seconds, the minutes setting stops and the hours
setting increases (or decreases).
During the time setting phase, the seconds remain at "00".

2. Meter display and reset

Press key "i" (27) to display the meters.
The following message will appear on the display (5):
!COUNTERS MENU
N° coffee
N° milk
N° water
N° steam
N° steam+air
N° tot coffee
N° cycles
To access the various menus, position the cursor on the line
that interests you, using the "+" (30) or "-" (31) keys.

3. How to access the programming mode

N.B. ONLY if the item "Customer Progr." is set on "YES" and
the item "Program. block" is set on "NO".
To access programming press the PRG (29) key; the following
message will appear on the display:
! CUSTOMER PROG.
KEY MENU
Access to menus: press a selection key.
Access and modification of sub-menus: Use the "+" (30)
and "-" (31) keys to position the cursor (black line) on the
desired line, then press the PRG (29) key.
!KEY MENU
Type
repetition
Water dose
MM1 cof, dose
MM2 cof, dose
Water Start
+
u
25
15
10
5
9
56
u
95
+
u
1 coffee
001
110
043
000
400
u
56
19 April
wednesday
Press the PRG (29) key and then press the "+" (30) and "-" (31)
keys to reset the number. The meter will be reset.
The total number of coffees and the number of cycles cannot
be zeroed.
The total number of grinding procedures recorded for the two
grinders (MM1 and MM2) can only be zeroed by the installer
technician when the grinders are replaced.
When the "OK" key is pressed, zeroing is confermed.
Press the RES (24) key to return to the main menu.
Use the "+" (30) and "-" (31) keys also to modify the message
or number.
Note: When modifying data, the cursor changes to "! ! ! ! ! ".
Exiting the programming menu
Machines WITH the OK key
there are two possibilities:
1) Press the OK key to confirm changes
2) Press the RES (24) key to leave settings unchanged and exit
the menu
If the "Customer Progr." is set to "NO", the following message
will appear on the display:
!!!!!!!!!!!!!!!!!!!!
CUSTOMER PROG.
NOT ENABLED!
!!!!!!!!!!!!!!!!!!!!
English
2006
15:15:04