Using The Kettle; Cleaning And Maintenance - TEFAL TRAVEL CITY KO120127 Manual De Instrucciones

system where you are using a coin,
for example. If the voltage selected
is 120 V, the kettle operates
between 100 and 120 V. If 240
V is selected, the kettle operates
between 220 and 240 V.
ATTENTION! Check, if necessary,
that you have an adapter
which complies with the safety
standards of the country.

USING THE KETTLE

1 Pull up to open the cover (fig.3).
2 Place the kettle on a smooth,
clean and cool surface.
• Your kettle must only be used
with its own scale filter.
3 Fill the kettle with the required
quantity of water. (Fig 4)
• You can fill the kettle by the
spout, which helps to keep the filter
in good condition. Otherwise, at
least cover the heating coil (or the
bottom of the kettle).
• Do not fill the kettle when it is
plugged into the mains.
• Do not fill the kettle above the
maximum level. If the kettle is
overfilled, boiling water may spill
over the top.
• Do not use without water.
4 Close the cover by pressing
down firmly.
• Check that the lid is closed
correctly before use.
5 Plug into the mains.
6 To start the kettle.
• Press the l/0 button at the top of
the handle. (fig 6)
7 The kettle will stop
automatically.
• As soon as the water boils, you
can stop the kettle manually by
pressing the l/0 button. Depending
on the model, the light inside the
kettle or the indicator light will be
extinguished when the water boils.
Check that the l/0 button is in the 0
position after the water has boiled
and that the kettle is not operating
before unplugging it.
• Do not use the water from the
first two or three uses of the kettle,
as it could contain dust. Rinse the
kettle and the filter separately.
8 Storage of the kettle.
• Empty the water from the kettle,
and leave it to cool down before
wiping it dry. Wind the power cord
around the appliance. According to
the model, store it in the bag with
its accessories.
• If necessary, the bag may be
washed by hand.

CLEANING AND MAINTENANCE

Cleaning the kettle
• Unplug it.
• Leave it to cool down and clean
it with a damp sponge.
• Do not immerse the kettle, the
power cord or the plug in water: the
electrical connections and switch
must not be brought into contact
with water.
• Do not use scouring pads.
Cleaning the filter (depending on
model) (fig. 5)
21