Fitting The Sanding Sheet Onto The Sanding Plate; Changing Tools; Operation; Switching On And Off - Parkside PAMFW 12 C3 Traducción Del Manual De Instrucciones Original

Materials
Mortar/concrete residues, tile/carpet glue, paint/
silicone residues
Application
–
removal of material residues, such as carpet
glue residue on the floor .
Sanding plate
Materials
Wood and metal (sanding sheets
wood*, metal*
* depending on the sanding sheet
Application
–
sanding up to edges and hard to reach areas .
Fitting the sanding sheet onto
the sanding plate
♦ Place the sanding sheet
sanding plate .

Changing tools

NOTE
► If you wish to use the dust collection, it must be
connected before fitting the tool (see section
"Connecting a dust extraction device") .
WARNING! RISK OF INJURY!
■ Always remove the battery before working on
the power tool .
♦ If necessary, remove an already fitted tool .
To do this, raise the tool release lever
♦ Fit the tool (e .g . the plunge saw blade
the tool fitting .
PAMFW 12 C3
supplied),
centrally on the
.
) onto
NOTE
► You can fit the tools in any snap position on
the tool fitting .
♦ Fix the tool in place by pushing the tool release
lever back down again .
■ Check that the tool is fitted firmly. Incorrectly
or insecurely fitted tools can come loose during
use and cause you an injury .

Operation

Switching on and off

Switching on
♦ Push the ON/OFF switch
the appliance on .
The LED work light
ance is switched on to light up the working area
in low light conditions .
NOTE
► The LED work light
without dust extraction unit
Switching off
♦ Push the ON/OFF switch
switch the appliance off .

Select oscillation speed

♦ Use the speed adjustment wheel
required oscillation speed .
Stage 1: low oscillation speed
Stage 6: high oscillation speed
NOTE
► The required speed depends on the material
being worked and on the working conditions
and can be determined through practical
tests .
forwards to switch
lights up when the appli-
may only be used
.
backwards to
to set the
GB │ IE │ 9 ■