Fitting The Sanding Sheet Onto The Sanding Plate; Changing Tools - Parkside PAMFW 12 A1 Traducción Del Manual De Instrucciones Original

Application:
–
removal of material residues, such as tile adhe-
sive, when replacing damaged tiles
–
milling of grout on wall and floor tiles.
Scraper
Materials:
Mortar/concrete residues, tile/carpet glue, paint/
silicone residues
Application:
–
removal of material residues, such as carpet
glue residue on the floor.
Sanding plate
Materials:
Wood and metal (sanding sheets
wood*, metal*
*depending on the sanding sheet
Application:
–
sanding up to edges and hard to reach areas.
│ GB │ IE
■ 20
Fitting the sanding sheet onto the
sanding plate
♦ Place the sanding sheet
sanding plate

Changing tools

NOTE
► If you wish to use the dust collection, it must be
connected before fitting the tool (see section
"Connecting a dust extraction device").
WARNING! RISK OF INJURY!
■ Always remove the battery before working on
the power tool.
♦ If necessary, remove an already fitted tool.
To do this, raise the tool release lever
♦ Undo the tensioning screw
(Only for diamond saw blade
♦ Fit the tool (e.g. the plunge saw blade
the tool fitting.
NOTE
► You can fit the tools in any snap position on
the tool fitting.
♦ Tighten the tensioning screw
mond saw blade
by pushing the tool release lever
again.
■ Check that the tool is fitted firmly. Incorrectly
or insecurely fitted tools can come loose during
use and cause you an injury.
supplied),
centrally on the
.
.
).
(Only for dia-
) and fix the tool in its place
back down
PAMFW 12 A1
.
) onto