Orbegozo AP 4200 Manual De Instrucciones página 17

AP 4200
POWER VAC ASSEMBLY
Before using your cleaner
Remove all packaging and lay out the separate components. Check the unit after unpacking for any visual
damage such as:
- Misaligned or damaged parts
- Damage to the main body and separate components
- Damage to the plug or cable.
If you can see any damage do not use the cleaner and contact customer services.
Ensure the power is switched off before assembling.
1. Insert the assembled handheld vacuum unit into the main frame as shown on the diagram -suction inlet
first then securing the handle into place.
2. Align the bottom of the frame with the connector on the ball joint of the floor head, lowering the frame
until it is securely in place. Ensure the pins are correctly aligned. Tilt the cleaner forward so it stands up
independently.
3. Lift the main handle up until it 'clicks' into place. Note: Take care not to trap skin or hair.
4. The main vacuum unit is now assembled.
CHARGING YOUR POWER VAC
Before using for the first time you will need to charge the cleaner.
1. First, assemble the charging stand. Before charging ensure the cleaner is switched off.
17