Orbegozo AP 4200 Manual De Instrucciones página 22

Aspirador 3 en 1
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

AP 4200
The suction is decreasing
and the cleaner is not
picking up dirt
Cleaner is over heating
The charging stand is not
working
Dust is coming out of the
vacuum cleaner
The air coming out of the
vacuum cleaner smells
Disposal of old electrical appliances
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be collected separately in order to optimize the
recovery and recycling of the materials they contain, and reduce the impact on human health and
the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low Voltage
Directive 2014/35/EU and the requirements of the EMC directive 2014/30/EU.
The power button has not been
pressed
Dust container
Filters are dirty
Handheld/head blockages
Filters are dirty
The unit is not fitted correctly
on the stand or the stand is not
correctly plugged in to the
mains
Dust container fitting
Filters are dirty
Filters are not dry
Make sure you have turned on the power using
either the main unit power button or the
handheld power button
Check if the dust container is full, if so, empty
it.
Clean the filters. After around 6 months of
regular use the filters may need replacing.
Check that there are no blockages in the
handheld suction inlet or cleaning head. If so,
clean them.
Check that the filters are not blocked. If so,
clean them following the instructions in this
booklet
Make sure that the unit is fitted correctly on
the charging stand and the charging adaptor is
plugged into the mains
The dust container has not been fitted
correctly. Refit the container following the
instructions in this booklet
Clean the filters and dust container
Ensure the filters have been left to dry for 24
hours before refitting back into the vacuum
cleaner and using
22

Publicidad

Tabla de contenido
loading

Tabla de contenido