Orbegozo AP 4200 Manual De Instrucciones página 18

AP 4200
2. Plug the charging cable into the adaptor socket on the back of the charger dock and insert the charging
plug into a suitable 13 Amp mains socket, pressing the switch on.
3. Lift the assembled cleaner onto the charger dock, ensuring that the lip on the back of the unit clips onto
the charging dock and secures correctly. There is an additional charging port that can be found in the
back of the hand held vacuum cleaner, shown in the diagram below.
The charging indicator light on the handheld vacuum will illuminate red, flashing in 2 second intervals to
show that the unit is charging.
A full first time charge should be given, of 3-5 hours.
Once charged, the indicator light will illuminate solid red.
Note:
The body may become warm during charging and this is completely normal.
•
Make sure the battery is charged when the product will not be used for prolonged periods of time.
•
USING YOUR VAC
Once assembled and charged:
1. Lift the cleaner off the charging dock and place on the floor.
2. Support the floor head with your foot and pull back the handle
3. Press the main unit power button to start the power at the lower setting. Press again for higher speed
setting.
4. Move the cleaner floor head in a forwards and backwards motion over the areas you would like to clean.
Note: Large items can get trapped in the brush/floor head which could cause the unit to overheat. Make
sure you pick up larger items that could get trapped before vacuuming.
5. To turn off the power, press the power button.
18