Problem Solving - Orbegozo AP 4200 Manual De Instrucciones

AP 4200
You can fold the handle by pressing in the handle release button and folding backwards.
It is not recommended to remove the floor head.
To clean the exterior of the device, use a damp, soft cloth and mild detergent.
Wash non-electrical removable accessories in warm soapy water and allow to dry thoroughly before next
use.
If the cleaner is damaged, contact the customer service helpline using the details at the bottom of this
page.
Storage
Store it in a clean and dry environment.
Checking for blockages
To check for blockages, remove the floor head from the main body of the vacuum cleaner and check the
floor head and neck of the upright for dust and dirt that may have built up. Blockages could also occur
around the nozzle of the hand held vacuum.

PROBLEM SOLVING

PROBLEM
The cleaner won't turn on
NEVER IMMERSE THE CLEANER IN WATER.
POSSIBLE PROBLEM
The cleaner hasn't had enough
charge
Charging cable is damaged
POSSIBLE SOLUTION
Make sure you have plugged in the cleaner to
charge for 3 hours. The light will flash when
charging
Make sure there is no signs of damage to the
charging cable
21