Fm Operation - Lenco SR-05 BT Guia Del Usuario

Please make sure the aerial on the back of the radio is fully extended and adjusted before
you attempt to tune to an FM station (a vertical position is recommended). This will ensure
that the maximum signal strength is available, get the best possible sound quality.
Enter FM mode
Press the SOURCE button on the front panel or remote control to enter FM mode.
(Frequency: 87.5-108.0MHz)
Mono/Stereo
Press MO/ST button on remote control or press TUNER KNOB on the front panel to switch
stereo on, if the radio reception is weak, it can not turn stereo on.
Search station
Press SEARCH button on the front panel or
stations. It stops searching after searching all the stations. (Pressing this button will
automatically clear the stored stations.)
Stations tuning
Briefly rotate the TUNER KONB on the front panel or press TUNE+/- buttons on remote
control to tune the radio up or down by frequency step of 0.05MHz.
Select stations
There are default stations whenever you turn on the unit with good radio signal reception.
1. Briefly press or
the previous or next station.
2. Long press or
of strong reception.
3. Use NUMBER buttons to select stations
E.g. to listen to station 15, press 1, then 5 to select 15th station.
Select frequency
If you know the frequency of the wanted stations, you can press F button then NUMBER
buttons to select frequency.
E.g. to listen to FM 103.50MHz, press F button, then press Number buttons 1,0, 3, 5, 0,
to enter 103.50MHz. (The Zero must input to enable the frequency.)
Store stations (you may store 60 stations as presets)
1. Enter the station you want to save ,refer to the above methods.
2. Press PRESET button on the remote control to enter preset status.
3. Use NUMBER buttons to select presets number.
4. Press PRESET button again to confirm and save.
E.g. to store 105.30MHz into station 9, first enter the station 105.30MHz, press PRESET
button then press NUMBER buttons to select 9, at last press PRESET button to save
the station.
RDS mode
Each time you press RDS button on the remote control to display the radio information:
<Program service>, <Program type>, <Radio text>, <Clock Time>. The display
information is provided by the radio broadcasting stations. Some stations may not
provide.
All manuals and user guides at all-guides.com

FM operation

on the remote control or on the front panel to sequentially select
on the front panel or remote control to the next or previous station
directly
8
on remote control to search all the available
.