VDS iLoft Kit
VDS iLoft Kit
VDS iLoft Kit
VDS iLoft Kit
VDS iLoft Kit
VDS iLoft Kit
VDS iLoft Kit
VDS iLoft Kit
VDS iLoft Kit
VDS iLoft Kit
2. When in the User menu, enter in ADMINISTRATOR menu (pressing F1 + F2 simultaneously
for 5 seconds). Once in the ADMINISTRATOR menu, select the first option.
2
¸
5"
F1 F2
a
b
a) Hundreds: Press the
b) Tens: Press the
c) Single unit: Press the
4º. Exit Programming: Press the «OK» to confirm the selected number. You return to the
previous programming menu.
Pag 12
Select the first option:
+
The first thing the monitor then does is indicate the
number of the current monitor on the SCREEN. If it is
not programmed, it will show the following: - - -
Note: When the terminal has not been programmed
the blue led will flash very slowly.
3º. Programme the call number: Each time the button
corresponding to hundreds, tens or single units is
pressed, the figure goes up that figure and is shown
on the DISPLAY.
c
button
button
button
Administrator Menu
The icons viewed on-screen are controlled
via the corresponding buttons on the moni-
tor.
Once you reach 9, if you press it again,
it returns to 0. The next time you press, it
will start at 1.