Fermax iLOFT Manual De Instalador Y Usuario página 63

VDS iLoft Kit VDS iLoft Kit VDS iLoft Kit VDS iLoft Kit VDS iLoft Kit VDS iLoft Kit VDS iLoft Kit VDS iLoft Kit VDS iLoft Kit VDS iLoft Kit
Lock Release / Call Guard Unit Button
· Pressing this button whilst communicating with the Entry Panel will activate the lock
release.
· Pressing this button whilst the monitor is on standby will result in a call being made
to the guard unit (where one exists).
Note: If the channel is busy an error tone «BEEP» will sound and auto-start will
not activate, nor will the call to the guard unit.
Auto-Start / Main-Secondary Camera Selection Button
· With the monitor on standby, press this button for 1 second to switch the monitor
on manually. To activate the audio, press the
· With video, hold this button down for 2 seconds to sequentially select between
the main camera and the secondary camera (if there is one).
Note:
- If the channel is busy an error tone «BEEP» will sound and auto-start will not
activate, nor will the call to the guard unit.
- The auto-start function is always used on the main panel except where a call
is received on the secondary panel. Once the conversation is over, auto-start
will activate on the secondary panel for 30 seconds. After this time it will
activate on the main panel.
F1 and F2: Buttons for Additional Functions.
(Assigned by the installer; see the corresponding chapters).
NOTE: The monitor screen goes on once the call from the panel has ended.
Operation
Opening the Door
When a call is received from the entry panel, you can open the
door at any time, by pressing the
button.
button.
Pag 29