Preparing Kitchen Units; Parts Included; Power Requirements; Planning Notes - Gaggenau BM 450 710 Instrucciones De Instalación

Before You Begin
Tools and Parts Needed
▯
Torx head screwdriver
▯
1/8" drill bit and drill
▯
Measuring tape

Parts Included

▯
Microwave oven
▯
2 Torx screws

Power Requirements

This appliance requires connection to a dedicated
208/240V branch protected supply fitted with a
suitably approved 20A circuit breaker. It must be
properly grounded in accordance with all applicable
codes. The product is supplied with 1.8 m of flying
cables in a flexible conduit which are factory fitted.
The colors of the conductors are:
▯
L1: Red
▯
L2: Black
▯
N: White
▯
E: Green/Yellow

Planning notes

Door hinge not interchangeable.
Distance from furniture body to door front 1
(47 mm).
Distance from furniture body to outer edge of door
handle 3¾" (94 mm) after retrofitting the handle
(special accessory).
Pay attention to the front protrusion, possibly
including the door handle, for opening drawers at the
sides.
When planning a corner solution, pay attention to the
door opening angle of at least 90°.

Preparing kitchen units

Kitchen units must be temperature-resistant up to
195° F (90 °C) and adjoining furniture frontages up
to 160° F (75 °C).
Cut recesses on the furniture before inserting the
appliance. Remove any shavings, as these can affect
the operation of electrical components.
Refer to the installation drawings on the following
pages.
Secure unsecured furniture items to the wall using a
commercially available bracket.
Only install the appliance so high that accessories
can be removed with ease.
/ "
7
8
7