DeWalt DW341 Traducido De Las Instrucciones Originales página 29

Dust Extraction (Fig. 5)
The dust extraction adaptor (M) in combination with
the dust extraction shroud (N) helps extracting the
dust from the workpiece surface, when connected
to a suitable dust extraction system.
1. Place the dust extraction shroud (N) between
the finger guard (F) until it clicks in place.
2. Fit the dust extraction adaptor (M) to the tool
as shown.
3. Connect the hose of a suitable dust extraction
system to the adaptor.
WARNING: When appropriate, connect
a dust extraction system designed in
compliance with the applicable directives
regarding dust emission.
WARNING: Do not use a dust extraction
system without proper spark protection
when sawing metal.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING:
• Make sure your workpiece is well
secured. Remove nails, screws and
other fasteners that may damage
the blade.
• Check that there is sufficient space for
the blade underneath the workpiece.
Do not cut materials that exceed the
maximum cutting depth of the blade.
• Use sharp saw blades only. Damaged
or bent saw blades must be
removed immediately.
• Do not use the tool for sawing pipes
or tubes.
• Never run your tool without a
saw blade.
• For optimal results, move the tool
smoothly and constantly over the
workpiece. Do not exert lateral pressure
on the saw blade.
Keep the shoe flat on the workpiece
and lead the cord away in line with
the tool. When sawing curves, circles
or other round shapes, push the tool
gently forward.
• Wait until the tool has come to a
standstill before removing the saw
blade from the workpiece. After sawing
the blade may be very hot. Do
not touch.
Proper Hand Position (Fig. 1, 8)
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper
hand position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the
front handle (S), with the other hand on the main
handle (R) or one hand on the main handle (R).
Switching On and Off (Fig. 1)
DW341K
To run the tool, press the on/off switch (A).
For continuous operation, press and hold down the
switch (A), press the lock-on button (B) and release
the switch.
To stop the tool, release the switch.
To stop the tool in continuous operation, press the
switch briefly and release it. Always switch off the
tool when work is finished and before unplugging.
DW343K
1. To run the tool, slide the on/off switch (A) to
the front.
2. To stop the tool, slide the on/off switch to the
rear. Always switch off the tool when work is
finished and before unplugging.
Setting the Electronic Sawing Speed
(Fig. 6, 7)
DW341K (FIG. 6)
The sawing speed varies with the pressure exerted
on the on/off switch (A).
To preset the sawing speed, turn the control dial (C)
to the desired level. The higher the rate, the higher
the sawing speed. The required setting depends on
the thickness and kind of material.
Use high speeds for sawing soft materials such as
wood. Use low speeds for sawing metal.
DW343K (FIG. 7)
The speed control dial (C) can be used for advance
setting of the required range of speed.
english
27