Optional Accessories - DeWalt DW341 Traducido De Las Instrucciones Originales

english
Turn the electronic speed control dial to the required
level. The required setting depends on the thickness
and kind of material.
Use high speeds for sawing soft materials such as
wood. Use low speeds for sawing metal.
WARNING: After using the tool for an
extended period on low speed settings,
run it for approx. three minutes on
maximum no-load speed.
Sawing in Wood
1. If necessary, draw a cutting line.
2. Switch the tool on.
3. Hold the tool against the workpiece and follow
the line.
4. For sawing parallel to the edge of your
workpiece, install the parallel fence and guide
your jig saw along the workpiece a shown in
figure 9.
Sawing in Wood Using a Pilot Hole
1. If necessary, draw a cutting line.
2. Drill a hole (ø min. 12 mm) and introduce the
saw blade.
3. Switch the tool on.
4. Follow the line.
5. For cutting perfectly round shapes, install the
trammel bar and set it to the required radius
(Fig. 10).
Sawing Up to a Projecting Edge
(Fig. 1, 11)
1. Using a conventional blade, cut up to the
projected edge.
2. Finish off the cut using a flush cutting blade.
Dust Extraction (Fig. 5)
When the tool is used indoor for extended periods
of time, use a suitable dust extractor designed in
compliance with the applicable Directives regarding
dust emission.
Sawing in Metal
1. Mount an appropriate saw blade.
2. Proceed as described above.
WARNING: Use a cooling lubricant
(cutting oil) to prevent overheating of the
saw blade or the workpiece.
28
MAINTENANCE
Your D WALT power tool has been designed
e
to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and
regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
The charger and battery pack are not serviceable.
Lubrication
Your power tool requires no additional lubrication.
Apply a drop of oil to the guide roller (H) at regular
intervals to prevent jamming.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
been tested with this product, use of
such accessories with this tool could be
hazardous. To reduce the risk of injury,
only D WALT recommended accessories
e
should be used with this product.
WALT, have not
e