Installation
CAUTION
• For instructions on how to mount the display, consult your dealer.
• Do not install the display where it may (i) obstruct the driver's vision, (ii)
impair the performance of any of the vehicle's operating systems or safety
features, including airbags, or (iii) impair the driver's ability to safely oper-
ate the vehicle.
• PIONEER does not recommend that you install or service your display your-
self. Installing or servicing the product may expose you to risk of electric
shock or other hazards. Refer all installation and servicing of your display to
authorized PIONEER service personnel.
• If this product is installed in a place where it is visible to the vehicle's driver,
you MUST always set the [DISPLAY SETTING] to the [FRONT] setting.
Failure to do so could result in distracting images being potentially visible to
the driver while the vehicle is in motion.
If this product is installed in a place where it is not visible to the vehicle's
driver, then you may choose the [REAR] location setting.
Use of this product is subject to any local laws regarding placement or use.
PIONEER Corporation cannot accept any liability for any problems, dam-
age or loss incurred as a result of the product being used with an incorrect
setting or in violation of any local laws.
• Install the display between the driver's seat and front passenger seat so that
it will not be hit by the driver or passenger if the vehicle brakes sharply.
• Do not install the display in a position where the fully opened air bag will be
obstructed by it.
• Do not install the display in a place where it will impair the performance of
any of the vehicle's operating systems, including airbags.
• Make sure there is nothing behind the panelling when drilling holes in them.
Be careful not to damage fuel lines, brake lines or power cables.
• When using screws, do not allow them to come into contact with any electri-
cal lead. Vibration may damage wires, leading to a short circuit or other
damage to the vehicle.
• It is extremely dangerous to allow the display lead to become wound around
the steering column or shift lever. Be sure to install the display in such a way
that it will not obstruct driving.
• Make sure that leads cannot get caught in a door or the sliding mechanism of
a seat, resulting in a short circuit.
32