Care And Servicing Of Your Andis Trimmer Blades; Correct Disposal Of This Product - Andis TC-2 Instrucciones De Uso Y Cuidado

Ocultar thumbs Ver también para TC-2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into
Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil.
With this detachable blade unit, you can change your blade in order to maintain a
comfortable temperature.

CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES

Blades should be oiled before, during, and after each use. If your trimmer blades
leave streaks or slows down, it's a sure sign blades need oil. The trimmer should be
held in position shown (Figure G) to prevent oil from getting into motor. Place a few
drops of Andis Clipper Oil on the front and side of the cutter blades (Figure H). Wipe
excess oil off blades with a soft dry cloth. Spray lubricants contain insufficient oil for
good lubrication, but are an excellent trimmer coolant. Always replace broken or
nicked blades to prevent injury. You can clean the excess hair from your blades by
using a small brush or worn out tooth brush. To clean the blades we suggest to
immerse the blades only into a shallow pan of Andis Blade Care Plus, while the
trimmer is running. Any excess hair and dirt that has accumulated between the
blades should come out. After cleaning, turn your trimmer off and dry blades with a
dry cloth and start clipping again.
REMOVAL OF BLADE SET
To remove the blades, first unplug the trimmer from the electrical outlet. Hold the
trimmer so that the blade teeth are pointing up. Press forward on blade (Figure I).
REPLACEMENT OF BLADE SET
Align blade yoke armature pin in correct position before replacement of blade set
(Figure J). To replace the blade, line up the bottom hook of blade set with the slot on
the trimmer and snap into place (Figure K).
FACTORY REPAIR SERVICE
When the blades of your Andis trimmer become dull after repeated use, it is advised
to purchase a new set of blades available through your Andis supplier or through an
Andis authorized service station. If you wish your trimmer to be serviced as well, it
should be carefully packed and mailed either Parcel Post Insured, or U.P.S. to any
Andis authorized service station.

CORRECT DISPOSAL OF THIS PRODUCT

This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
CAUTION: Never handle your Andis trimmer while you are operating a water
faucet and never hold your clipper under a water faucet or in water. There is
danger of electrical shock and damage to your clipper. ANDIS COMPANY will not
be responsible in case of injury due to this carelessness.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido