Blade Replacement - Cembre HT-TC026 Manual De Uso Y Mantenimiento

ENGLISH
g – Remove all air from reservoir.
If the oil level is low, top up as directed in § 4.2.
h – Fit reservoir cap (01).
i – Assemble main handle (03) to tool body.
If the tool continues to malfunction return the tool for service/repair as detailed in § 6.
4.2) Oil top up
Every six months check the oil level in the reservoir. If necessary, top up the oil level to the top lip
of the reservoir and remove all air from reservoir, see § 4.1, points a, b, c and e, fi nally, complete
with operations h and i.
Always use clean recommended oil, see § 1.
Do not use old or recycled oil.
Do not use hydraulic brake fl uid.
Ensure that disposal of used oil, is in accordance with current legislation.

4.3) Blade replacement

After extended use, the blades may loose their cutting edge. Replace the blades as follows:
4.3.1) Lower blade: (Ref. to Fig. 4)
– Release latch (25) and open the tool head.
– Operate moveable handle (40) to advance the lower(24) blade until holding screw (26) is visible
on the ram (28).
– Using a fl at blade screwdriver remove the holding screw (26) and release the lower blade.
– Insert the new blade and fi t the holding screw.
Warning: before closing the tool head release the oil pressure and retract the lower blade, otherwise
the head may hit and damage, the lower blade.
4.3.2) Upper blade: (Ref. to Fig. 5)
– Release latch (25) and open the tool head.
– Remove the circlip (59) and partially extract the head pin (15), enough to release the tool head
assembly.
– Remove circlip (29) and pin (23), to release the latch (25).
Remove latch spring (22) from the spacer (19).
– Using a 10 mm spanner, remove 8 nuts (16), 8 washers (18) and 4 studs (17), releasing the blade (21).
– Position the new blade in the head assembly, insert 4 studs (17), fi t 8 washers (18) and 8 nuts (16).
Insert the latch spring (22) into the spacer.
Fit the latch using the pin (23) and circlip (29) and tighten the 8 nuts.
– Fit the head assembly to the head support using the pin (15) and circlip (59).
6