How To Assemble Your Ceiling Fan - Fanimation Zonix FP4640B Serie Manual Del Usuario

How to Assemble Your Ceiling Fan

1.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for
reinstallation in Step 6. (Figure 1)
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3.
Loosen the two set screws and locking nuts in the
downrod support of the motor assembly. Route the
black, white, blue wires and safety cable through
the downrod. (Figure 3)
4. Insert downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
Hanger
Ball
Hairpin Clip
Set Screws
and Nuts (2)
Downrod
Support
Clevis Pin
7
Pin
Set Screw
Figure 1
Clevis Pin
Figure 2
Black, White, Blue
Wires and Safety
Cable
Downrod
Figure 3
Hairpin Clip
Set Screws (2)
Figure 4