How To Install Your Canopy Housing; Mounting The Fan Blades And Switch Cup Cover Assembly - Fanimation Zonix FP4640B Serie Manual Del Usuario

How to Install Your Canopy Housing

NOTE: This step is applicable after the neccessary
wiring is completed.
1. Assemble canopy by rotating key slot in canopy
over shoulder screw in hanger bracket, taking care not
to pinch the wires. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that was
previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket
utilizing the key slot twist-lock feature. (Figure 2)

Mounting the Fan Blades and Switch Cup Cover Assembly

To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1. Securely fasten the three blades with phillips-head
screws with flat washers. (Figure 1)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
2. Disassemble switch cup support cover from switch
cup cover assembly removing three screws. (Figure 2)
WARNING
WARNING
3/16"-24
Phillips Head Screws
Flat Washers
12
Figure 1
Figure 2
Phillips-Head
Screw with
Flat Washer
(3 per blade)
Figure 1
HARDWARE USED:
Switch Cup Support Cover
Figure 2
Ceiling
Canopy
Canopy Screw
Cover
x 9
x 9