Checks, Regulations And Adjustments; Starting - Daikin ZANOTTI AS Serie Manual De Uso Y Manutención

9

Checks, regulations and adjustments

9.1

Starting

ATTEN TI ON
M edium tem perature range :
Low tem perature range :
OFF : Unit is operating normally.
5. DISPLAY : on connection to the mains it shows OFF to indicate the condition of the
unit. By pressing ON/OFF key for 5 seconds the unit is turned ON and the display
shows the cold room temperature. In programming mode the parameters to be set
are displayed; in alarm mode the alarm code is displayed.
6. "SET" key : when pressed it lights up and allows room temperature to be set.
During programming it is used to pass from a submenu to an upper one.
7. "DOWN/ROOM LIGHT" key: in programming mode or when setting room
temperature it is used to reduce the value displayed; otherwise it is used to switch
on/off the cold room light.
8. "SB.M./UP" key: in programming mode it is used to increase the values displayed.
If pressed for more than 5 seconds it enables manual defrost to be carried out.
9. "ON/OFF" key: when pressed for 5 seconds it turns the unit on or off.
10. "Enter" key: it gives access to programming menu and submenus. Access
to the programming mode requires the installator's assistance and should
be effected only if necessary.
Before turning the unit on, check that:
- locking screws are tight
- electrical connections have been carried out correctly.
In the event that the unit has been opened:
- no tools were left inside
- assembly is correct
- there are no gas leaks
- front cover is secured correctly
Before starting the unit act as follows:
Connect the unit to the mains. The display is turned on and shows OFF.
-
If the unit has a preheating cycle, leave it in this condition for at least 3 hours.
-
If the unit has a voltage monitor, leave it in this condition for at least 7 minutes to
-
have the counting phase carried out
Set the required cold room temperature.
-
- Press ON/OFF key for 5 seconds to switch the unit on.
+10 -5°C
-15 -25°C
27