Intended Use - Worx WG568E Manual Del Usuario

Waste electrical products should
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your Local
Authority or retailer for recycling
advice.
Cordless Li-ion Blower/Sweeper
ASSEMBLY
aSSEMBLiNG tHE BLOwEr tUBE (See Fig.
a & B)
ALWAYS REMOVE THE BATTERY PACK
BEFORE aSSEMBLiNG tHE BLOwEr
tUBE
Fit the Blower Tube to the motor housing as
shown in Fig. A. Check the Blower Tube is
firmly secured.
NOtE: Before disassembling the Blower Tube,
be sure the variable speed trigger is on off
position. Press the Release Button (7), so that
you can separate the tube (See Fig. B). Do not
try to separate the tubes by force or by using
tools.
OpERATiON

iNtENDED USE:

The blower is intended for blow debris.
not intended for use indoors and animal
grooming.
warNiNG! The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
1. BEFOrE USiNG yOUr COrDLESS
BLOwEr
Your battery pack is UNCHARGED and you
must charge once before use.
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
2. CHarGiNG yOUr BattEry PaCK
The Li-ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit.
in a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
it's
11
EN