Intended Use; Assembly And Operation - Worx WG512 Manual De Instrucciones

OPERATION

INTENDED USE

The blower & vacuum is intended for residential use
only. Use the blower outdoors to move or vacuum
yard debris as needed.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
Assembling the Blower/Vacuum
Tube
Attaching/Removing the Leaf
Collection Bag (vacuum mode
only)
Attaching the Shoulder Strap
(supplied with WG514 only)
NOTE: There are two positions for
attaching the strap.
OPERATION
Converting from Vacuum to Blower
NOTE: Press either (a) or (b)
release button to turn the blower/
vacuum selector knob until the
knob clicks in place and is aligned
with the corresponding arrow
marking on the machine.
Converting from Blower to Vacuum
NOTE: Press either (a) or (b)
release button to turn the blower/
vacuum selector knob until the
knob clicks in place and is aligned
with the corresponding arrow
marking on the machine.
Attaching the Extension Cord
Starting & Stopping
WARNING:
-The tool runs for a few seconds
after it has been switched off. Let
the motor come to a complete
standstill before setting the tool
down.
12 AMP All-in-One Blow/Vac/Mulch
Multiple Speed Adjustments
• Two-speed Adjustment (only
for WG512, WG514)
Note:
-To maximum vacuum
performance, it is better to use the
II mode.
- The I mode is only recommended
when vacuuming in sensitive areas
FIGURE
(i.e. flower beds)
• Variable Speed Adjustment
(only for WG513)
Note: The speed of the blower
See Fig. A
can be altered by rotating the On/
Off switch.
See Fig. B1,
Using the Blower
B2
CAUTION!
—For maximum vacuum
See Fig. C1,
performance, it is better to use the
C2
II high speed mode.
—Do not operate the blower near
bystanders or pets.
—Use extra care when cleaning
debris from stairs or other tight
areas.
See Fig. D1,
—Wear safety goggles or other
D2
suitable eye protection, long pants
and shoes.
Using the Vacuum
WARNING:
—For vacuuming, make sure
the tube and bag are installed in
See Fig. D3,
position, or else the machine can
D4
not start.
CAUTION!
—Do not vacuum solid objects
such as carpentry wood blocks,
large branches, broken glass, or
pieces of metal and stones.
See Fig. E
Emptying the Leaf Collection Bag
See Fig. F
NOTE:
It is recommended to empty the
collection bag contents when the
bag is 75% full.
-Normal usage of the Debris
Collection bag causes it to wear
and deteriorate over time. A worn
or deteriorated bag allows small
objects to be thrown through
the bag, possibly injuring the
operator or bystanders. Check
the bag frequently. If it is worn or
deteriorated, replace it with a new
WORX debris collection bag.
WARNING:
See Fig. G1,
G2
See Fig. G1,
G2
See Fig. H
11
See Fig.
I1, I2
EN