Intended Use; Assembly And Operation; Cleaning The Tool - Worx BRUSHLESS MOTOR WG591 Manual De Instrucciones

OPERATION

INTENDED USE:

The blower is intended for residential use only. Use the blower outdoors to move yard debris as needed.

ASSEMBLY AND OPERATION

Assembling & disassembling the Blower Tube
Installing & Removing the Battery Pack.
NOTE: Depress the battery release button to release battery pack from your
tool. After recharging, insert the battery pack into tool's battery port. A simple
push and slight pressure will be sufficient.
Checking the battery charger condition
Your battery pack is UNCHARGED, you must charge before use.
Charging the battery
More details can be found in WA3859's manual
WARNING! The charger and battery pack are specially designed to work
together, so do not attempt to use any other devices. Never insert or allow
metallic objects into your charger or battery pack connections because of an
electrical failure and hazard will occur.
Starting & Stopping
WARNING! The tool runs for a few seconds after it has been switched off.
Let the motor come to a complete standstill before setting the tool down.
Blowing
USER TIPS
- Hold the blow tube approximately 8" above the ground when operating the tool.
Use a sweeping motion from side to side. Advance slowly keeping the
accumulated debris/leaves in front of you.
- After blowing the debris/leaves into a pile, it is easy to dispose of the pile.
CAUTION!
- Do not blow hard objects such as nails, bolts, or rocks.
- Do not operate the blower near bystanders or pets.
- Use extra care when cleaning debris from stairs or other tight areas.
- Wear safety goggles or other suitable eye protection, long pants,
and shoes.

CLEANING THE TOOL

Clean the tool regularly.
WARNING: Keep your product dry. Under no circumstances spray with water.
- To clean the tool, use only mild soap and a damp cloth.
- Do not use any type of detergent, cleaner or solvent which may contain chemicals
that could seriously damage the plastic.
- Self lubricating bearings are used in your product, therefore lubrication is not required.
Cordless Li-Ion Blower
Action Figure
See Fig. A&B
See Fig. C&D
See Fig. E
See Fig. F
See Fig. G
9
See Fig. H
EN