SSS Siedle SK 600-0 Manual De Instrucciones página 6

English
About this document
This Manual offers information
required for commissioning the
SK 600-...
During compilation of the Manual,
attention was paid to ensuring
that it may be understood even by
beginners.
Despite this, in certain areas, spe-
cialist IT expertise is helpful as an aid
to understanding.
Intended readers
This Manual is aimed at:
• Installers
• Service technicians
• Administrators
• Users
Explanation of symbols
Direct access button, e.g.
reception/concierge
Alphabetical name
search
Alphabetical group
search
Direct input of a number
Login at the user level
Logout from the super-
visor level
Deactivate the touch-
panel for 30 seconds for
cleaning
One menu step back
6
Terminate menu
Setting the volume
Conditions
A number of steps have to be
executed for commissioning the
SK 600-...:
• System completely installed and
ready for operation
• Laptop with network adapter
• The laptop must be located in the
same network as the SK 600-...
• Installed configuration program
SK 600-...
Remarks
• Login password: admin
• The SK 600-... behaves in the
Vario bus in the same way as a DRM.
• Inadmissible symbols in the name
are: „ " /n ;
Programming
Programming takes place using a
laptop connected via the network to
the panel. To allow communication
to take place, both devices must be
located in the same IP address area.
Configuration of the IP address:
Configuration of the IP address takes
place directly at the touch panel.
1 Actuate the Siedle logo for 5 sec-
onds
2 Actuate Login to User Level
3 Enter the password, which is
"admin" in the as-delivered status,
and confirm with ENTER.
4 Actuate the Siedle logo in order
to enter the Supervisor Level
5 Actuate the Siedle logo in order
to enter the Service Menu
6 Actuate the network set-up
7 By actuating the IP address, an
input mask opens which allows
the address to be adjusted. The
relevant subnet mask is pre-set
to 255.255.255.0 and cannot be
altered here.
8 Enter the IP address and confirm
with ENTER
Configuration program SK 600-...
9 Start the program. The basic data-
bases are written and opened in the
directory C:\Users\Username\Siedle\
SK_600.
9a Dashboard
Preview start screen
9b Data transmission
Read or write the complete configu-
ration or transfer only the call logs to
the SK 600-...
9c Simulation
Here, all settings can be tested prior
to transfer.
9d Languages
The main language must be
selected. From the second selected
language, the top-most button is
replaced by this.