Operation; Operating Instructions; Charging - Porsche Mobile Charger Connect Manual Del Propietário

Operation

Operation

Operating instructions

In some countries, the relevant authorities must be
notified when you connect electric vehicle charging
equipment.
e
Check obligation to notify the authorities and le-
gal requirements for operation before connecting
charging equipment.
NOTICE
Damage to the charger
e
Always place the charger on a solid surface when

charging.

e
Porsche recommends that you use the charger
in the basic wall mount or in the charging dock.
In some countries, e.g. Switzerland
may only be used in the basic wall mount or in
the charging dock.
e
Do not immerse the charger in water.
e
Protect the charger from snow and ice.
e
Handle the charger with care and protect it from
potential damage from being driven over, drop-
ped, pulled, bent or crushed.
e
Do not open the charger housing.
NOTICE
Damage to the charger
− 1. Time of printing: Further information is available from your authorized Porsche dealer.
24
The charger must only be operated within a tem-
perature range from -22 °F to +122 °F (-30 °C to
+50 °C).
e
To prevent overheating during operation, avoid
continuous exposure of the charger to direct
sunlight. If the charger overheats, charging will
be interrupted automatically until the tempera-
ture has returned to the normal range.
e
If the charger is too hot or too cold, let it return
slowly to the operating temperature range and
do not actively cool it down or heat it, e.g. by
cooling it down with cold water or heating it with
a hairdryer.
, the charger
1
Charging
Notes on charging
Vehicle charge port
For information on connecting and disconnecting the
vehicle cable to and from the vehicle charge port and
for the charging and connection status at the vehicle
charge port:
g See Owner's Manual.
Electric shock, fire
DANGER
Risk of serious or fatal injury due to fire or electric
shock.
e
Always observe the specified sequence for the
charging process.
e
Do not disconnect the vehicle cable from the
vehicle charge port during the charging process.
e
End the charging process before disconnecting
the vehicle cable from the vehicle charge port.
e
Do not disconnect the charger from the electrical
socket during the charging process.
Errors are shown on the display and are indicated by
red status LEDs. The error message, the cause and a
remedial measure will be displayed.
e
Refer to chapter "Malfunctions" on page 35.
Charging times
The charging duration can vary depending on the
following factors:
–
Electrical socket used (domestic electrical outlet
or industrial electrical outlet)
–
Country-specific power grid voltage and current