GYS STARTPACK PRO 12.24 Manual De Instrucciones página 13

Translation of the original instructions
STARTPACK PRO 12.24 EN
4
3
USE IN STARTER MODE
• Unplug the socket from the mains.
• Turn the battery-switch on OFF.
• Plug the red clamp to the (+) and the black clamp to the (-).
NB: In the event of polarity inversion, STARTPACK PRO 12.24 indicates red LED lighting + alarm
sound.
• Connect the voltage selector on 12V or 24V depending on the the vehicle you wish to start.
• Turn the battery switch to ON
• Turn the key of your vehicle (5 seconds maximum) in order to activate the starter function
NB : if the vehicle does not start, wait 3 minutes between two attempts.
A vehicle which does not start after the third attempt probably has a problem unrelated to the bat-
tery: alternator, spark plug,...
• Once the vehicle starts, turn the battery switch on OFF.
After a start or a high consumption of batteries, the red light will flash to warn you that internal
batteries should be recharged. This doesn't mean that you can't try to start other vehicle.
• Disconnect the voltage selector from the 12 V or 24 V socket.
• Unplug the black clamp then the red clamp from the vehicle.
• Connect the device on a 230 V 50/60 Hz socket to recharge the batteries (cf. use in charger mode).
13