Battery Replacement - GYS STARTPACK PRO 12.24 Manual De Instrucciones

Translation of the original instructions

BATTERY REPLACEMENT

3
5
Product
STARTPACK PRO 12.24
Regardless of how the STARTPACK PRO 12.24 is being used, always replace both batteries at the same
time.
To replace the batteries:
• The booster must be disconnected from the power supply.
Unscrew the back panel ( 1 - 11 screws) and remove it.
•
• Once the back panel is removed, the batteries are visible, one on top of the other (see picture).
• The batteries are maintained by a partition (striped area
the - terminal and at the + terminal.
Start with the top battery. Firstly, unscrew the partition completely 2 , then unscrew the two nuts at the - termi-
•
nal and at the + terminal of the battery 3 and remove it.
Once the first battery is removed, make sure to insulate the terminals to prevent any short circuit.
• Then, do the same with the bottom battery. Unscrew the partition 4 , then unscrew the two nuts used to connect
the battery to the STARTPACK 5 and remove the battery.
When putting new batteries in, make sure to match the polarities of both batteries and START-
PACK PRO 12.24. Reassemble the batteries in the following order:
Reposition and tighten slightly the bottom partition 4 . Then insert the battery, screw it back 5 et resserrer com-
•
plètement la cloison. Faire de même avec la batterie du haut. Do the same with the bottom battery. Position the
partition first and tighten lightly 2 , insert the battery, screw it back on 3 and tighten the partition completely. Place
16
the booster back panel screws back on. 1 .
STARTPACK PRO 12.24
1
2
4
Battery Type
PC950 Lead acid battery
2
4
Voltage (V) Capacity (Ah)
2 x 12 2 x 30
) and connected to the STARTPACK at two points: at
EN
3
5
Dimensions (cm) Battery ref
25 x 9,7 x 15,6 53135