GYS STARTPACK PRO 12.24 Manual De Instrucciones página 15

Translation of the original instructions
TROUBLESHOOTING, CAUSES, SOLUTIONS
Alarm sound and red LED is on
1
The red LED flashes.
2
Sparks when connecting clamps
to the vehicle battery.
3
The device cannot start the
vehicle, the red LED flashes.
4
The product cannot start the
5
vehicle, and the red LED is off.
Orange and green LEDs are
flashing after 24h or charge.
1
Orange and green LEDs flash al-
ternatively during the charge
2
The orange LED flashes for more
than 3 hours and does not turn
to green.
3
STARTPACK PRO is plugged in to
the mains but no light is on.
4
NO WARRANTY ON BATTERIES
STARTPACK PRO products contain 2 high performance batteries, which require to be recharged after each use. In case
this is not carefully applied, batteries can deteriorate in an irreversible way.
For this reason, STARTPACK PRO batteries are excluded from the warranty.
STARTPACK PRO 12.24
Anomalies
The product detects an inversion
of polarity.
The battery voltage went lower
than 12.5V after a start or a
heavy consumption.
The battery switch is turned ON
and/or the voltage selector is on
12V or 24V.
The voltage selector is on the
wrong position.
Polarity inversion.
Internal batteries are discharged. Recharge the machine to the
Many starting attempts without
recovery time.
A start should not last for more
than 5 seconds.
Internal batteries voltage is really
low. They can be damaged.
Internal batteries are damaged.
Voltage of batteries does not in-
crease despite the charge.
Charger is on thermal protection
The battery is sulphated or dee-
ply discharged.
No voltage from the mains.
The voltage connector is not
plugged on the 12V socket.
The fuse has blown
Causes
Check the polarity on the battery.
Red clamp to the (+) of the bat-
tery and black clamp to the (-).
Charge the device after use. The
red LED will turn off.
Before connecting the clamps on
the vehicle battery, turn the bat-
tery-switch OFF, and disconnect
the voltage selector.
Check that the selected voltage
corresponds to the voltage of the
vehicle's battery
Check polarity on the battery
max, and try again
Wait 3 minutes between two
starting attempts.
Vérifier que la tension de la bat-
terie du véhicule correspond bien
à la tension sélectionnée.
Put the product on recharge to
attempt recovery of internal bat-
teries.
Unplug the machine from the
mains, and then restart the
charge. If the problem persists
the batteries are damaged.
Charger is overheating because
the room temperature is too
high. The charger will restart the
charge automatically as soon as
the temperature dropped down
sufficiently.
Normal process of the product:
the charger detects the presence
of sulphated / deeply discharged
batteries. It will attempt to re-
cover the battery with a specific
charge of 16h.
Check the presence of 230V vol-
tage on the supply.
Plug the voltazge connector on
the 12V socket.
Replace the fuse.
EN
Remèdes
15