General Information; General Maintenance - Philips AZ 1009 Instrucciones De Manejo

GENERAL INFORMATION

General maintenance

Do not expose the set, batteries, CDs, or tapes to humidity,
rain, sand, or excessive heat (caused by heating equipment or
direct sunlight).
The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated!
You can clean the set with a soft, slightly dampened, lint-free cloth.
Do not use any cleaning agents as they may have a corrosive effect.
Tape deck maintenance
To ensure proper recording and playback quality, clean parts
A, B and C after approximately 50 hours of operation. Use a
cotton swab slightly moistened with alcohol or head-cleaner fluid.
Press PLAY 1 and clean the rubber pressure roller A.
Press PAUSE ; and clean the capstan B and the heads C.
Note: Cleaning of the heads C can also be done by playing a
cleaning tape once.
CD player and CD handling
The lens X of the CD player should never be touched. Always
keep the CD compartment closed to avoid dust on the lens.
The lens may cloud over when the set is suddenly moved from cold
to warm surroundings. Playing a CD is not possible then. Leave the
CD player in a warm environment until the moisture evaporates.
To take the CD out of its box easily, press the centre spindle while
lifting the CD. Always pick up the CD by the edge and put it back
in its box after use.
To clean the CD, wipe it in a straight line from the center toward
the edge using a soft, lint-free cloth. A cleaning agent may
damage the disc!
Never write on a CD or attach a sticker to it.
This set complies with the radio interference requirements of the
12
European Community
A
B
C C
X