Closing Command - GiBiDi BA24 Instrucciones De Instalación

Ocultar thumbs Ver también para BA24:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
40
UK
EXTERNAL CLOCK
C16
CLOSING ALLOWED
(set automatic closing)
EXTERNAL CLOCK
C17
CLOSING NOT ALLOWED
(set automatic closing)
EXTERNAL CLOCK
C18
AUTOMATIC OPENING AND

CLOSING COMMAND

C20
PHOTOCELL 1 TEST
Enables the RESERVE input for the connection of an external clock.
Operation:
When the clock closes the contact on the RESERVE input, following a
START command the door will open but not close automatically. When
the contact on the RESERVE input is opened, the door will
Y
automatically close after the pause time.
When the door is open, the closing command can be given with "start"
if the menu is STEP-BY-STEP or STEB-BY-STEP with STOP.
WARNING: remember to preset the automatic closing
N
Disables the RESERVE input
Enables the RESERVE input for the connection of an external clock.
Operation:
When the clock closes the contact on the RESERVE input, following a
START command the door will open but not close automatically. When
Y
the contact on the RESERVE input is opened, the door will
automatically close after the pause time.
It is not possible to activate the closing with the "start" command.
WARNING: remember to preset the automatic closing.
N
Disables the RESERVE input
Enables the RESERVE input for the connection of an external clock.
Operation:
When the clock closes the contact on the RESERVE input, an opening
command will automatically be activated without needing to give a
Y
START command. When the contact on the RESERVE input is opened,
the door will automatically close after the pause time.
WARNING: remember to preset the automatic closing.
N
Disables the RESERVE input
Enables the Photocell 1 test.
The photocell 1 transmitter must be connected to the clamps 14 and 17.
Operation:
Y
When the "Start" or the "Pedestrian" command is given, the power to
safety devices is cut off for 0,5 and then restored: if the photocell 1 input
opens and immediately returns NC the motors start, otherwise a fault will
be signalled by 4 blinks (1 sec.) of the flashing light.
N
Disables photocell 1 test.
BA24

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

S05100

Tabla de contenido